User Manual

9
Installation
The Elite Wired Microphones with Mute Control and Indicator are equipped
with a 15' (4.5 meter) cable that allows integration with audio equipment. If
the microphone mute is controlled locally, only the audio wires (mic positive
(red), mic negative (black), and ground) need to be connected to the audio
equipment.
If external mute control is being implemented, and the LED indicator on the
microphone is controlled externally, the switch out (green), LED in (blue) and
I/O ground cables also need to be connected to the GPIO ports controlling the
behavior.
Dip switch Settings
The DIP switches manage the behavior of the mute
control (mute button) and the LED indicator light on
the microphone. The switches are located on the
bottom of the microphone and numbered 1 through 6.
To access the DIP switches, remove the bottom door of
the microphone using a screwdriver or similar tool to
press on the latch and then remove the door. Set the
DIP switches based on the following tables to achieve
the intended behavior.