Owner's Manual

– 1 –

Checking the included items

Remove all parts from the package and make sure you have

all of the items.

•Bench board 1

•Legs 4

•Foot rest 1

•Bolts 4

•Washers 4

•Screws 4

•Wrench* 1

*Wrench is attached on the backside of bench board.

Bench assembly

1 Turn the bench board over and install two

legs for the front side.

Tighten the bolts using the included wrench (as

shown).

CAUTION

Make sure to put washers between the bolts and the

bench board. Make sure to properly tighten all bolts so

that there is no gap between the bolts and the washers.

If the bolts are not properly tightened, accident or injury

may occur.

2 Install the foot rest to the legs with the

included four screws, using a screwdriver.

3 Install the two legs for the back side.

Have a Phillips-head (+) screwdriver of the appropriate size

ready.

Washer

Bolt

Logo is written on back

After completing the assembly, be sure to read the

“PRECAUTIONS” section of the Owner’s Manual of

ELS-02/ELS-02C.

Foot rest

Bench for ELS-02/ELS-02C Owner’s Manual

PAGE 1
Bench for ELS-02/ELS-02C Owner’s Manual 2 Checking the included items Remove all parts from the package and make sure you have all of the items. • Bench board 1 • Legs 4 • Foot rest 1 • Bolts 4 • Washers 4 • Screws 4 • Wrench* 1 Install the foot rest to the legs with the included four screws, using a screwdriver. Foot rest *Wrench is attached on the backside of bench board. 3 Install the two legs for the back side. Have a Phillips-head (+) screwdriver of the appropriate size ready.
PAGE 2
Post-assembly checklist If the bench is unstable After completing the assembly, please check the following. If the bench is unstable, adjust it in the following manner. • Are all of the bolts and screws properly tightened?  Make sure to properly tighten all bolts and screws. 1 With the legs on the floor in the normal position, temporarily loosen the bolts indicated with a mark written on them.