Owner's Manual

Rhythm Sequence Program
ELS-02/ELS-02C Owner’s Manual
175
10
Rhythm Program
The Registration Sequence is programmed from this
display. The entered Registration number is shown
along the Registration row in the middle of the
display.
2 Select a Bank, then press the desired
numbered button in the Registration
Memory section.
3 Using the buttons in the
display or the Data Control dial, set the
Measure/Beat/Clock position at which
you want to change the Registration (1
beat = 96 clocks).
When using the Data Control dial, first press the
number you wish to change in the display, then turn
the dial.
4 Press the DATA [SET] button in the
display.
The Registration number appears in the display (in
the timing order), indicating that the Registration is
entered. Up to 140 Registrations can be entered.
If some Registration numbers are entered to the
same Measure/Beat/Clock, the last entered one takes
priority.
5 Repeat steps 2 through 4 above to set
the Registration Sequence.
Entering Next Unit:
When you program the Next Unit function in
Registration Sequence, the next registration data in
current Song can be loaded automatically just by playing
the Rhythm Sequence.
1 Using the buttons in the
display or the Data Control dial, set the
Measure/Beat/Clock position at which
you want to enter the Next Unit (1 beat =
96 clocks).
2 Press the NEXT UNIT [INSERT] button in
the display.
The Next Unit mark appears at the timing point
you set in step 1, indicating that the Next Unit is
entered.
You can move or delete the entered Registration
Sequence (Registration number or Next Unit data) from
the sequence.
To move an entry:
1 Using the POSITION buttons, move the
cursor and select the data (Registration
number or Next Unit) you want to move.
2 Change the position by pressing the
Bar/Beat/Clock buttons in the display.
3 To move the Registration number
timing, press the DATA [SET] button. To
move the Next Unit timing, press the
NEXT UNIT [SET] button.
The position of the Registration number or Next
Unit is changed and displayed in the proper order.
Next Unit Loading Time
• Loading a Next Unit may take a few seconds (the time
may differ depending on the size of the data to be
loaded).
• Next Unit data can be loaded by two ways: using the right
footswitch and programming Next Unit in the
Registration Sequence. Loading time is the same
regardless of which way you load the Next Unit data.
Editing an existing Registration
Sequence