User Manual

Changing the Song Name
ELS-02/ELS-02C Owner’s Manual
116
8 Press the [CUSTOM PLAY] button to
start recording of the part selected in
step 6 (Upper part).
Playback of the previously recorded parts starts
immediately.
The [CUSTOM PLAY] button is used here to record
only the parts that have been selected for recording,
and plays back only those parts that have been
selected for playback. While you listen to the parts
being played back, start playing the melody on the
Upper Keyboard.
When the end of the recorded performance is
reached, playback is automatically stopped. The
length of a subsequently recorded part cannot
exceed the length of the previously recorded parts.
This lets you re-record a specific phrase or section which
you don’t want to use, either that of a specific part(s) or
all parts.
NOTE
This function is best used when the phrase to be re-recorded
has definite beginning and end points, with slight pauses before
and after.
1 Select the Song which contains the
phrase you want to change.
For details on selecting a Song, see page 112.
2 Press the [R] (Play) button to start
playback of the Song.
3 Press the [K] (Pause) button at the
point you want to execute punch-in
recording.
4 Press the [I] (Record) button.
The Recording display appears, indicating that the
Music Data Recorder is ready to record.
5 Set the parts which you want to change
to “REC” status and other parts to
“PLAY.”
6 Press the [R] (Play) button to start
punch-in recording. Play the new
phrase, as you want it to be changed.
7 Press the [J] (Stop) button to quit the
punch-in recording as soon as you
reach the end of the phrase.
Changing the Song Name
You can name the Song, such as giving it a title or
indicating the date on which it was recorded. However,
Song names of EL-series Electones, such as the EL-900,
cannot be changed.
NOTE
When you change the name of an XG Song, the extension (.mid)
cannot be changed.
1 Select the Song whose name you want
to change.
For details on selecting a Song, see page 112.
2 Press the [TOOLS] button at the top
right of the display to call up the TOOLS
Page.
3 Press the [CHANGE NAME] button.
The following display appears.
4 Move the cursor to the desired point by
using the [L] [R] buttons in the display
or the Data Control dial.
Punch-in recording
Cursor