User Manual

Using the LCD Display

ELS-02/ELS-02C Owner’s Manual

Quick Introductory Guide

To open the parameter list:

When you press a button, a parameter list will appear in

which you can select the desired parameter. When you

select items in the display, the list closes automatically.

You can also close the list by pressing the [CLOSE] button

at the top right of the list.

To change the parameter value:

To make coarse changes to the value, use the []/[]

buttons. For fine adjustment, use the Data Control dial.

You can adjust some parameters such as Volume, Reverb,

Pan and so on, by using the ‘virtual’ sliders in the display.

There are two ways to move the slider in the display:

touching it directly, and using the Data Control dial. We

suggest that you touch the display slider when making

coarse adjustments and use the Data Control dial for fine

adjustment.

Touching the display slider directly:

To change a display slider value, press the desired point in

the slider. The slider moves to the point that is pressed.

You can also change the parameter value by sliding your

finger up or down while holding down on the display

slider.

Using the Data Control dial:

Touch on/above the slider in the display to enable the

parameter and set a rough value, then turn the Data

Control dial.

To control Pan, you can move the horizontal slider in the

same way as vertical sliders.

Adjusting parameter values by

using the display sliders

DATA CONTROL

Slider will move to the point you touch

Slider will follow your finger

DATA CONTROL

Touch here to enable the parameter

Blue mark

DATA CONTROL