User Manual

Rhythm Pattern Program
ELS-02/ELS-02C Owner’s Manual
162
3 Select the User Rhythm number to
which you wish to save.
The following display appears, prompting
confirmation of the operation.
4 Press the [SAVE] button to save the
pattern, or press [CANCEL] to abort the
operation.
After saving the Rhythm, be sure to quit Rhythm Pattern
Program before turning the power off. Turning off the
Electone without quitting Rhythm Pattern Program
erases the User Rhythm you have created.
You can quit the Rhythm Pattern Program from any of its
display pages.
1 Press the [PATTERN] button.
If a rhythm is playing, it will automatically be
stopped.
If you leave Rhythm Pattern Program without
having edited any patterns, this simply quits the
Rhythm Pattern Program.
If you have not saved the edited pattern, a message
appears, prompting confirmation of the operation.
2 Select [EXIT] to leave Rhythm Pattern
Program, or [CANCEL] to abort the
operation and return to the previous
display.
NOTICE
When you leave the Rhythm Pattern Program, the
square at the top left in the display turns light blue for a
few seconds, indicating that data is currently being
saved. Do not turn the power off while the data is being
saved.
Checking the Remaining Memory
Capacity
Remaining Memory (amount of memory available for
storing rhythms) is shown on the display as a percentage.
If a “Data full” message appears when you press the [SAVE]
button, the pattern cannot be saved because of lack of
available memory space. If this occurs, check through all
fifteen sections for any unnecessary data. After erasing
some of the less necessary data, try to save the pattern
again.
To avoid this, you should periodically check the amount of
remaining memory while you are creating your rhythm.
Reference pages
• Confirming rhythm patterns before saving (page 161)
• CLEAR PART (page 150)
Remaining Memory
Quitting the Rhythm Pattern
Program