User Manual

Confirming the Electone Version
ELS-02/ELS-02C Owner’s Manual
23
1
Quick Introductory Guide
Confirming the Electone
Version
You can confirm the version of your Electone by the
following procedure.
1 Press the [UTILITY] button.
The Utility display appears.
2 On the GLOBAL page, press the
[Version] button in the display.
The Version dialog appears in the display. Pressing
[OK] closes the dialog.
About the latest Firmware Version
Yamaha may from time to time update firmware of the
product without notice for improvement. We recommend
that you check our web site for the latest releases and
upgrade your firmware of the Electone.
http://download.yamaha.com/
Note that the explanations in this Owner’s Manual apply
to the version of firmware when this Owner’s Manual was
produced.
Factory Set (Initializing
the Electone)
All current settings including Registration Memory, User
Voices, User Rhythms, and LCD display settings can be
deleted at once by the following procedure. Note that the
operation here does not affect the settings of the wireless
LAN settings, which can be initialized on page 200.
Reference page
• Saving Registrations (page 118)
• Initialize the wireless LAN settings (page 200)
1 Turn off the power.
2 While holding down the ENDING [1]
button, turn the power back on.
3 Release the ENDING [1] button after
Voice Display appears.
If you don’t want to reset the LCD display settings, you
can initialize only the Registration settings. See page 98
for more information.
Reference page
• Initializing Registration Memory (page 98)
NOTICE
Executing the Factory Set will erase all your existing data.
Always save your important data to the USB flash drive.
123
ENDING