User Manual

17
EMX7 Owner’s Manual
System Setup
There are two amplifier modes:
• STEREO:
When using the SPEAKERS A/B channel for L/R stereo. Pro-
vides common 2-channel stereo output.
• L+R/AUX1:
When using the SPEAKERS A channel for L+R mono, and
the SPEAKERS B channel for AUX1. The L+R signal is sent
to the main speaker and the AUX1 signal is sent to the moni-
tor speaker for the performers.
1. Call up the SYSTEM SETUP screen. (For more
information about the screen procedures, see
page 15.)
Selecting the Amplifier Mode
CAUTION
When selecting the amplifier mode, set the AUX1 and
STEREO MASTER [LEVEL] controls to “0.” This prevents
excessive output from the [SPEAKERS A/B] jacks when
switching the amplifier mode.
SYSTEM SETUP screen
2.Turn the [MENU/CONTROL] rotary encoder
until the cursor highlights the AMP MODE
parameter box.
3.Press the [MENU/CONTROL] rotary encoder
so that the parameter box is fully highlighted.
4.Turn the [MENU/CONTROL] rotary encoder to
change the Amp Mode parameter. You can
choose between STEREO and L+R/AUX1
modes.
5.Press the [MENU/CONTROL] rotary encoder
to confirm your selection.
The AMPLIFIER [MODE] indicators on the front panel
show the current amplifier mode. (See section #2 on page
13.)
NOTE
To return to the HOME screen, operate the [PROGRAM]
rotary encoder.
Parameter box
1. Call up the SYSTEM SETUP screen. (For more
information about the screen procedures, see
page 15.)
2.Turn the [MENU/CONTROL] rotary encoder
until the cursor highlights the CONTRAST
parameter box.
3.Press the [MENU/CONTROL] rotary encoder
so that the parameter box is fully highlighted.
4.Turn the [MENU/CONTROL] rotary encoder to
set the Contrast parameter. The contrast can
be set to any value from 0 to 10, providing 11
different contrast levels.
Setting the LCD Contrast
SYSTEM SETUP screen
Parameter box