Service manual

16
EMX68S / EMX88S
4. PWR Circuit Board 4/4
(Time required: about 4 min)
4-1. Remove the front panel assembly. (See Procedure 1)
4-2. Pinch slightly the stopper of the power switch
escutcheon with a plyer, pull it to the front to
remove. (Fig.7-1)
4-3. Remove the two (2) screws marked [100]. (Fig.7-2)
4-4. Remove the power switch knob marked [120]. The
PWR circuit board 4/4 can then be removed.
(Fig.7-2)
(Fig. 7-1)
[100]: Bind Head Screw 3.0X8 MFZN2BL (VB659000)
[120]: Power Switch Knob MX12/4 (VU859000)
[50]
[70]
[60]
[80]
[90]
[70]
[60]
[80]
[90]
[60] [70] [90][90][50]
[40] [40] [40] [40] [40] [40] [40] [40] [40][40]
[60] [70] [90][90]
EMX88SEMX68S
[A] [A][41] [A] [A][41][41] [41]
[40]: Screw X25 MFZNBL (V3289800)
[41]: Bonding Tapping Screw-B 3.0X8 MFZN2BL (VN413300)
[50]: Knob GREEN/M-GRAY (V6225300)
[60]: Knob L-GRAY/M-GRAY (V6225600)
[70]: Knob BLUE/M-GRAY (V6225400)
[80]: Knob RED/M-GRAY (V6225500)
[90]: Knob L-GRAY/D-GRAY (V6225700)
(Fig. 5)
(Fig. 6)
[100][100]
[120]
[120]
(Fig. 7-2)