User Manual

55
Troubleshooting
Video Synchronized Recording/Playback
Symptom Remedy
Synchronized Songs are not played back. Make sure that the audio channels of the DVD recorder are correctly connected to the Disklavier.
Make sure that the input and output of the DVD recorder are correctly connected to the Disklavier.
Make sure that the “OMNI IN” option on the Disklavier is set to “Auto.”
Make sure that the “OMNI OUT” option on the Disklavier is set to “SYNC.”
Noise is heard during recording. Turn down the volume of the TV connected to the DVD recorder.
Disconnect the left side connector of the RCA cord from the OMNI OUT (L) jack on the Disklavier. This will not affect
the functionality of video synchronized recording.
Noise is heard during playback. The level of the synchronized signal (SMPTE) from the Disklavier may be too high. Turn down the level with the “SYNC
OUT Level” option and re-record.
Piano playback is not synchronized with the video. The video picture may be delayed on the projection device. Adjust the offset time with the “OMNI IN Delay” to match
the piano playing and the video picture.
The beginning of the piano performance drops out
when you play back the synchronized Song.
It may take some time until the Disklavier recognizes the synchronized signal and the piano begins to play back.
Select the synchronized Song in advance, and then start playback on the DVD recorder. Note that you should wait for
a while before playing the piano after recording begins on the DVD recorder.
Manual Development Group
© 2016 Yamaha Corporation
06/2020 MW-F0