User Manual

Table Of Contents
Troubleshooting
English
4
Chapter
24
The error indicator may flash in red when some error has occurred. Refer to the table below for an
explanation of the indication.
Example of Indication:
Error message also appears on the control screen of the ENSPIRE Controller app. To close the message,
tap on “Close” on the pop-up.
Pressing any of VOLUME +/– or PLAY/PAUSE buttons turns off the error indicator, and the VOLUME
indicators return to the previous status.
Error Indications
Indication Situation Remedy
Firmware update is failed. Turn the power off. Download the
update program and try to update
the firmware again. If the problem
still persists, consult your Yamaha
piano dealer.
Two or more USB flash memories
are connected at the same time.
You can use only one USB flash
memory at a time. Disconnect the
other USB flash memory.
The USB flash memory is
protected.
Unprotect the USB flash memory.
The wireless router (access point)
is not found.
Make sure that the wireless router
(access point) is turned on.
If you connect the Disklavier and
the wireless router (access point)
using an Ethernet cable, make
sure that the cable is firmly
connected to the wireless router
(access point).
The Disklavier cannot obtain the IP
address.
Check the settings of your network
devices.
The piano control unit does not
work properly.
Consult your Yamaha piano
dealer. If you are using the
ENSPIRE Controller app, please
tell them the message on the
screen.
Flashing
Lighting up
Twice
Twice