User Manual

19
Remote Antenna Receiver
The Remote Antenna Receiver consists of two pieces – the mounting plate and
the Antenna housing. The Remote Antenna Receiver is installed similar to a
wireless access point. Best locations are high on the wall or under the ceiling,
facing into the room in which the microphones are located. Each Remote
Antenna Receiver supports one Base DSP Unit.
The Remote Antenna Receiver contains several antennas to provide the best
transmission and reception of the radio signal to and from the microphones.
The back-plate of the Remote Antenna Receiver provides means to install the
antenna in different environments. See the diagram below.
Independent on which way the wall plate is attached, do not over-tight the
screws.
When installed on the wall or on an electrical one gang or two gang box the
network cable can be routed through the Network cable opening. Alternatively,
the network cable can be routed to leave the Remote Antenna Receiver either
on the top or the bottom, using the provided routing channels.
TOP
Four corner holes – wall installation
Four central holes – US single gang
or dual gang
Two outside horizontal holes –
European single gang
Two inside horizontal holes –
Under-ceiling installation
Network
cable
opening
Routing channels