User Manual

30
information about the standard LAN connection, including whether DHCP is
enabled or disabled, the IP address of the base DSP unit in the LAN network,
the MAC address of the interface, as well as other network information. The
Network Information (USB) option provides network information for the USB
connector on the front of the Elite base DSP.
System Settings
The System Settings submenu allows the user to control some of the Executive
Elite’s system settings.
The Remote Management checkbox at the top of the menu enables and
disables the room control (CLI) interface on the base DSP unit.
The Region menu allows selecting the region in which the Executive Elite
system is used.
NOTE: You need to select the region or country you are using the system
in. As part of this selection the frequency band in which the
Executive Elite system operates is selected. Selecting a country or
region different from the one you are in might revoke the right to
use the system. If you are unclear which region or country you
should select, please contact Yamaha Unified Communications
Inc. support. [e-mail]
The RF Power settings allow adjusting the RF signal strength of the receiver,
limiting RF traffic and interference with other areas. It is recommended to
select an RF setting that provides good RF coverage with minimal local area
interference. An RF Power setting that provides a signal strong enough for a
microphone to be 150 – 300 feet away from the remote antenna receiver might
also be seen by other Revolabs devices in the vicinity. We recommend testing
with different RF settings and using the RF Spectrum Analyzer in the local web
UI to gauge the effect of the different settings. Auto Scaling should be disabled,
System Settings
1. Remote Management
On/Off
2. Region
3. RF Power
4. DHCP On/Off
5. Admin settings
Region
1. USA/Canada
:
19. Middle East
RF Power
1. Auto Scaling On/Off
2.
0 – 20 ft (0 – 6 m)
:
6. 100 – 300 ft (30 – 90 m)
Admin settings
1. Set Password
2. Log Out