User Manual

Microphone Audio Page

The microphone audio page allows setting audio parameters for each

microphone individually. The page is structured into two areas. The top area

is set up for adjusting the input signal, and processing the signal by applying

filters, and EQ settings to the audio. The bottom of the table is focused on

output signal and an output gain stage as well as the microphone/line level

setting for the analog audio output.

Input Signal

The Input Signal area allows trimming the input signal for each microphone

separately, allowing for input levels of different microphones to be optimized

individually.

For XLR and TA4 adapters, an additional pre-gain stage is offered. The

Revolabs microphones (omni-directional, directional, gooseneck, and wearable)

are set to provide signals on the same level with a focus on providing the best

signal to noise ratio with the lowest risk of clipping of audio. XLR and TA4

adapters’ third party microphone elements are provided by the customer. The

pre-gain stage is provided to enable greater control over leveling the analog

signal of these microphones for highest signal levels without clipping. Please

ensure that signals are correctly set based on the microphone elements used

with these adapters.