User Manual

Batteries

Replace batteries in the microphones only with approved batteries!

The tabletop microphones require standard Nickel Metal Hydrate NiMH

rechargeable batteries with a 1.2 V voltage and a charge capacity of at least

1900mAh. Example batteries following these specifications are Sony

NHAAB4KN or Panasonic HHR-210AAB.

Yamaha Unified Communications, Inc. warranty is voided if a battery is

used that

 uses a different battery technology than rechargeable NiMH batteries,

 uses a battery with a different voltage than the required 1.2V,

 uses a battery with a lower charge capacity than the required 1900 mAh.

The wearable microphone, as well as the XLR and TA4 adapters use a custom

Li-Ion rechargeable battery. Use only Revolabs provided batteries for these

microphones. Using any other battery will void Yamaha Unified

Communications, Inc. warranty.

Caution: Risk of explosion if batteries are mishandled or replaced by an

incorrect type. Do not disassemble batteries or attempt to charge outside the

system. Do not dispose of batteries in fire. Dispose of batteries in accordance

with manufacturer’s instructions and local regulations.

Pairing Wireless Microphones to Remote Antenna and

Base DSP Station

Pairing creates a link between the Elite wireless microphone and the Base DSP

Unit through the Remote Antenna with a unique electronic serial number.

When the microphone and Base DSP Station have been previously paired, the

microphone will automatically try to connect (“link”) to the same Base DSP Unit

whenever it is lifted from the Charger Tray.

NOTE: New microphones in a system must be paired to the Base DSP Unit

with each microphone assigned to a unique channel on the base

unit.

NOTE: The microphone needs to be in range of the Remote Antenna

during the pairing process. Pairing is done wirelessly, the

microphone communicates through the Remote Antenna to the

Base DSP Unit during pairing.

A microphone that is not paired will be indicated by a cycling red-green LED

pattern. A Base DSP Unit channel that is not paired to a microphone will not