User Manual

- 24 -
Channels 25-32 Revo 25 - Revo 32
Channels 33-40 Revo 33 – Revo 40 (EU & CN Versions Only)
So for example, if you set the ‘Audio channels’ range for the microphones to 1-8, in the Control Panel,
then the Base Station will use the DSP channel name of “Revo 1” to control mute for the microphone
paired to channel 1 of the Base Station.
Note: Channel names are case sensitive and must be entered correctly to function properly.
Using the Base Station Front Panel Display
The Base Station has four or eight indicator LEDs (one for each channel) and pairing push buttons on
the front panel. (See Section Pairing Wireless Microphones to Base) When the LED is flashing
GREEN or RED, that channel is active and connected to a wireless microphone (GREEN is for live
audio, RED is for muted). When the LED is OFF, the channel is inactive (the microphone is out of
range or turned off).
The LCD and menu buttons are designed to provide the system installer the ability to access certain
configuration settings directly from the front panel instead of having to use the Revolabs HD Control
Panel software.
The user can choose to have the front panel display the current firmware, the current IP address and
box name, or the MAC address of the Base Station during normal operation. During a firmware
upload, the front panel will display the current progress of the firmware upload.
The following is a list of the configuration settings that can be changed using the front panel display
controls.
1. Select High Definition or Max Density modes
2. Select the Transmit Power of the Base Station
Navigation up
Navigation down
Return to Main Menu
Select Item
Backup one menu level