User Manual

- 30 -

To use the HD Universal Wireless Adapter:

17. Remove the Microphone Adapter from the Charger Base.

The adapter turns on and mutes automatically when removed from Charger Base (flashing RED

LED). The XLR Microphone Adapter is attached to a standard dynamic microphone to convert it

from a wired microphone to a wireless microphone (see following figure).

Note: The Adapter does not provide phantom power or bias current so it cannot be used with

condenser or electret microphones.

18. With the microphone attached, un-mute the Adapter by pressing and releasing the Mute button

(confirm by a flashing GREEN LED).

Note: If the microphone has an on-board mute switch, this switch must also be un-muted prior

to use.

19. To turn the Adapter off, return the microphone unit to the Charger Base or press and hold the

Mute button for ~10 seconds until the LED turns solid RED then release button.

Important: Always remove the microphone from the Adapter by pressing the latch switch and

separating the parts before returning the Adapter to the Charger Base.

If the Adapter is moved too far from the Base Station (~300 feet or 91 meters) the connection will be

dropped (LED flashes all colors) and the audio will mute. After 15 seconds the microphone will beep

5 times, and will continue beeping every 30 seconds to indicate that it is out of range.

Move the XLR Adapter closer to the Base Station and the connection will automatically be re-

established to its original state, and the beeping will cease. If not, the XLR Adapter will continue

beeping until it turns off in about 15 minutes.

Using the HD Wireless Adapter for Countryman Microphone

The HD Wireless Adapter for Countryman Microphones, shown in the following figure, is connects to

a Countryman microphones for wireless freedom for broadcasting applications with no bulky

equipment, such as a belt pack or batteries.