User Manual

Microphone Indicator Lights
Microphone in Charger Base
Microphone not in Charger Base
Microphone LED
Base Station
Meaning
OFF OFF Microphone powered OFF or
battery discharged
Two RED flashes every
1.5 seconds
Two RED flashes every
1.5 seconds
Microphone paired and muted
One GREEN flash every
1.5 seconds
One GREEN flash every
1.5 seconds
Microphone paired and “live”
Solid RED Solid RED Pairing mode or confirmation of
powering-down.
Alternating slow GREEN
and RED flashes
Alternating slow GREEN
and RED flashes
Microphone or channel not paired
YELLOW flash alternating
with GREEN flash
GREEN Flashing Microphone low battery
YELLOW flash alternating
with two RED flashes
RED Flashing Microphone low battery
(mic muted)
Alternating RED,
YELLOW, GREEN
flashes
OFF Searching for a connection, or out
of radio range. Microphone will try
to re-establish the link for about
15 minutes, and then turn off
automatically.
Rapid RED flashes
continuing for more than
a few seconds
OFF Radio congestion. Contact your
AV service provider for advice.
Groups of five rapid RED
flashes
OFF Unit is faulty. Contact your AV
service provider for advice.
Microphone LED Meaning
Solid RED Charging in Progress
Solid GREEN Charging Complete
How to Use Revolabs Wireless Microphones
x
LED Indicator — visual status for mute, un-mute, and pairing.
x Mute button — press to mute, un-mute and pair microphone.
Muting Revolabs Wireless Microphones
Revolabs HD Wearable Microphones turn on and mute automatically when removed from the
Charger Base. This reduces noise while being placed into position. The LED will cycle through
all of the colors upon initiation and then flash RED to indicate muted status Un-mute the
microphone by pressing and releasing the Mute button (flashing GREEN: un-muted).
Pairing Wireless Microphones to Base Station
Pairing creates a link between the HD Wireless Microphone and the Base Station, with a unique
electronic serial number. When the microphone and Base Station have been previously paired,
the mic will automatically try to connect to the same Base Station whenever it is lifted from the
Charger Base.
1. Turn the microphone OFF (no LED activity). If the microphone is ON, press and hold the
Mute button for 10 seconds until the
LED turns solid RED then release the
button to turn the unit off.
2. Put the Base Station into pairing mode
by pressing and holding the button for
the desired channel on the Base Station for seven seconds until the LED turns
solid RED, then release.
3.
Within 30 seconds, push and hold the Mute button on the microphone for seven seconds.
The LED will turn solid RED. Release the Mute button. Once pairing is complete, both
LEDs will flash GREEN, then switch to flashing RED (muted).
Yamaha Unified Communications, Inc.
144 North Road #3250
Sudbury, MA 01776 USA
[phone]
[e-mail]
Yamaha UC EMEA
190 High Street Tonbridge, Kent
TN9 1BE, UK
[phone]
[e-mail]
Yamaha UC APAC
+852.8108.8820
[e-mail]
Technical Support: https://uc.yamaha.com/resources/support/
Copyright 2018 Yamaha Unified Communications, Inc.