Instruction manual

Boat System
99
Tilt the outboard motor up using the PTT switch on the bottom cowling to decide
5.
the position where the tilt limiter is activated.
Do not use the PTT switch on the Digital Electronic Control during the tilt
limiter setting to avoid interference between the motor well and the cowling.
Recheck that there is no interference with the cowling.
6.
Click the [Set] button or press the [Enter] key on your keyboard.
7.
TIP:
When reconfiguring the tilt limiter setting, the [Next] button will appear instead of •
the [Set] button.
When setting the tilt limiter, take into account that the outboard motor actually •
stops at the position slightly lower than the corresponding tilt limiter setting
angle.
Set the tilt limiter setting angle within the setting angle range (approximately 53 •
to 66 degrees) where the tilt stop lever can be engaged.
A setting complete confirmation message appears.
8.
Click the [OK] button or press the [Enter] key on your keyboard.
9.