Instruction manual

Installation

This section provides information on installing the YAMAHA Diagnostic System on your computer.

This explanation assumes that you are installing in a Windows 7 environment. Where necessary, screenshots from Windows XP or Windows Vista will

be used.

Before installation1.

To use the YAMAHA Diagnostic System, the required component and device drivers must be installed at the same time as the Diagnostic System.

These will be installed automatically by the installer. Required components: [. NET Framework 3.5 SP1] or later, [Windows Installer3.1] or later.

The required components are pre-installed in Windows 7.

Before installing the YAMAHA Diagnostic System, make sure that your computer meets the speciﬁed requirements.

For detailed information on the system requirements, see “Hardware requirements.”

Start installation without the adapter connected to the computer, and then connect the adapter to the computer when installing the device drivers.

TIP:

It is strongly recommended that you quit all other programs before running the installer.