Service manual

POWR
Power unit
5-21
69J1D11
35. Install the ignition coil cover, wiring har-
ness guide, and flywheel magnet cover.
Replacing the timing belt
1. Remove the flywheel magnet cover, igni-
tion coil cover, and intake silencer.
2. Turn the flywheel magnet clockwise and
align the “1TDC” mark
a
on the flywheel
magnet with the pointer
b
, and check
that “I” marks
c
and
d
on the driven
sprockets are aligned with marks
e
and
f
.
NOTE:
Do not turn the flywheel magnet counter-
clockwise.
3. Remove the flywheel magnet.
CAUTION:
• Apply force in the direction of the
arrows shown, to prevent the flywheel
holder from slipping off easily.
• To prevent damage to the engine or
tools, screw in the flywheel puller set
bolts evenly and completely so that the
flywheel puller plate is parallel to the fly-
wheel magnet.
NOTE:
Apply force to the crankshaft end until the fly-
wheel magnet comes off the tapered portion
of the crankshaft.
4. Disconnect the ignition coil couplers, idle
speed control coupler, intake air pres-
sure sensor coupler, throttle position
sensor coupler, thermoswitch leads, idle
speed control hose, high-pressure fuel
hoses, neutral switch coupler, shift cut
switch coupler, and starboard fuel injec-
tor couplers.
È
Flywheel magnet holder
1
:
YB-06139
Universal puller
2
: YB-06117
È