Service manual

69J1D11
5-22
1
2
3
4
5
6
7
8
9
5. Disconnect the stator coil couplers
3
and pulser coil coupler
4
, and remove
the blowby hose
5
and stator coil
bracket
6
.
6. Remove the wiring harness guide bolts.
NOTE:
Move the wiring harness guide
7
to a posi-
tion that will make servicing easy.
7. Using a hexagon wrench, turn the timing
belt tensioner
8
clockwise to push the
timing belt, increase strength gradually,
and then insert a ø5.0 mm (0.2 in) pin
9
into the hole
g
.
NOTE:
Leave the pin inserted into the timing belt
tensioner until the timing belt has been
installed.
8. Remove the timing belt
0
from the
driven sprocket side.
9. Check that “I” marks
c
and
d
on the
driven sprockets are aligned with marks
e
and
f
, and that the “” mark
h
on
the plate is aligned with the “” mark
i
on the cylinder block. Align if necessary.
10. Install the timing belt
A
from the drive
sprocket side with its part number in the
upright position, turn the belt a half turn
counterclockwise to align it, and then
remove the pin
9
.
Power unit