Service manual

POWR
Power unit
5-57
69J1D11
6. Install half of the bearings
9
into the cyl-
inder block
0
.
7. Insert the projection
f
of the bearing into
the notch in the cylinder block.
NOTE:
Install the main bearings in their original posi-
tions.
8. Set the crankshaft
A
, and oil seal
B
,
and thrust bearings
C
into the cylinder
block as shown.
NOTE:
Apply engine oil to the inner oil seal and the
thrust bearings before installation.
9. Install half of the bearings
D
and the
thrust bearing
E
into the crankcase.
NOTE:
Install the main bearings in their original posi-
tions.
10. Apply sealant to the mating surface of
the crankcase.
11. Insert the projection
g
of the bearing into
the notch in the crankcase.
NOTE:
Do not get any sealant on the journal bear-
ings.
12. Install the crankcase onto the cylinder
block, and then tighten the crankcase
bolts to the specified torques in two
stages and in the sequence shown.
CAUTION:
Crankcase bolts
1
–
F
can be reused five
times.
S69J5F10
E