Service manual

LOWR
Lower unit
6-19
69J1D11
2. Install the needle bearing outer case into
the lower case.
NOTE:
Apply engine oil to the needle bearing outer
case before installation.
3. Install the needle bearing into the needle
bearing outer case.
NOTE:
Apply engine oil or grease to the needle
bearing, and then install it.
Assembling the forward gear
1. Install the new taper roller bearing into
the forward gear using a press.
Assembling the drive shaft housing
1. Install the needle bearing into the drive
shaft housing to the specified depth.
2. Apply grease to the new oil seals, and
then install them into the drive shaft
housing to the specified depth.
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Installing the drive shaft
1. Install the forward gear to the lower case.
Needle bearing installer
3
:
YB-06435
Pinion gear bushing installer
4
:
YB-06029-4
Needle bearing remover and installer
5
:
YB-06213
Forward gear bearing cup installer
1
:
YB-06276-B
È
È
Needle bearing installer and remover
1
:
YB-06194
Driver handle
2
: YB-06071
Depth
a
:
4.25–4.75 mm (0.167–0.187 in)
Oil seal installer
3
: YB-06195
Driver handle
4
: YB-06071
Depth
b
:
0.25–0.75 mm (0.01–0.03 in)
È