Service manual

69J1D11
6-20
1
2
3
4
5
6
7
8
9
2. Install the drive shaft housing
1
, thrust
bearing
2
, and original shim(s)
3
to the
drive shaft
4
.
CAUTION:
Add or remove shim(s), if necessary,
when replacing the drive shaft housing or
drive shaft.
3. Install the drive shaft and drive shaft
housing to the lower case, then the pin-
ion and pinion nut, and then tighten the
nut to the specified torque.
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
4. Tighten the drive shaft housing bolts.
Installing the propeller shaft housing
1. Install the washer
1
and propeller shaft
assembly
2
into the propeller shaft
housing assembly
3
.
2. Apply grease to the new O-rings.
3. Install the propeller shaft housing assem-
bly into the lower case.
4. Install the bolts
4
, ring
5
, and bolts
6
,
and then tighten the bolts
4
to the speci-
fied torque.
Installing the water pump and shift
rod
1. Install the shift rod assembly
1
.
Drive shaft holder
5
: YB-06201
T
R
.
.
Pinion nut:
142 N·m (14.2 kgf·m, 103 ft·lb)
È
T
R
.
.
Propeller shaft housing bolt
4
:
30 N·m (3.0 kgf·m, 22 ft·lb)
Drive shaft and lower case (regular rotation model)