Service manual

LOWR
Lower unit
6-37
69J1D11
Removing the propeller shaft
housing assembly
1. Remove the bolts
1
, ring
2
, and bolts
3
.
2. Pull out the propeller shaft housing
assembly.
Disassembling the propeller shaft
housing
1. Remove the spring
1
, and then remove
the cross pin
2
, dog clutch
3
, slider shift
plunger, and shift rod joint.
2. Remove the forward gear and forward
gear shim(s) from the propeller shaft
housing using a press.
3. Install the propeller shaft assembly in the
reverse direction into the lower case.
4. Remove the ring nut
5
and claw washer
6
.
5. Remove the bearing outer race
8
, taper
roller bearing
9
, thrust bearing
0
, and
propeller shaft shim(s)
A
using a press.
Slide hammer and adapters
4
:
YB-06096
Propeller shaft and bearing housing
remover
5
:
YB-06335
S69J6060
È
S69J6375
Bearing splitter plate
4
:
(commercially obtainable)
Ring nut wrench
7
: YB-06578