Service manual

CHK
ADJ
Periodic checks and adjustments
3-11
69J1D11
9. Place the throttle cam
0
against the fully
closed stopper
f
, and check that there
is a minimum clearance
g
of approxi-
mately 1.0 mm (0.04 in).
10. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin
h
on the throttle cam.
CAUTION:
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in)
i
.
11. Connect the cable joint, install the clip,
and then tighten the locknut.
12. Check the throttle cable for smooth oper-
ation and adjust the cable length, if nec-
essary, repeating steps 1–10.
Adjusting the throttle link and
throttle cable operation (without a
stop bolt)
NOTE:
• Be sure to synchronize the throttle valves
before adjusting the throttle link.
• For synchronizing procedures, see Chapter
4, “Synchronizing the throttle valve.”
1. Loosen the locknut
1
, remove the clip
2
, and then disconnect the throttle cable
joint
3
.
2. Loosen the locknut
4
and disconnect the
link rod
5
from the magnet control lever
6
.
3. Adjust the link rod
5
so that the align-
ment mark
a
is between the alignment
marks
b
. Then, push the magnet control
lever
6
in the direction of the arrow to
eliminate any looseness.
4. Install the link rod
5
and tighten the lock-
nut
4
.
S69J3300