Service manual

CHK
ADJ
Periodic checks and adjustments
3-13
69J1D11
5. Adjust the position of the shift cable joint
until its hole is aligned with the set pin.
CAUTION:
The shift cable joint must be screwed in a
minimum of 8.0 mm (0.31 in)
c
.
6. Connect the cable joint, install the clip,
and then tighten the locknut.
7. Check the gearshift for smooth operation
and adjust the shift cable length, if nec-
essary, repeating steps 3–6.
Checking the engine idle speed
1. Remove the ignition coil cover.
2. Start the engine and warm it up for 5 min-
utes.
3. Attach the special service tool to spark
plug wire #1
1
, and then check the
engine idle speed. Adjust if out of specifi-
cation.
4. Turn the engine off, loosen the locknut
2
, and then disconnect the link rod
3
from the magnet control lever
4
.
5. Loosen the port throttle stop screw
5
until it separates from the throttle body
lever
6
.
6. Start the engine, and then turn the star-
board throttle stop screw
7
in direction
a
or
b
until the specified engine idle
speed is obtained.
S69J3370
Inductive self-powered tachometer:
YU-08036-B
Engine idle speed: 650–750 r/min