Owner`s manual

Operation
37
Adjust the outboard motor trim angle using
the power trim and tilt switch.
To raise the bow (trim-out), press the switch
“” (up).
To lower the bow (trim-in), press the switch
“” (down).
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
NOTE:
To adjust the trim angle while the boat is
moving, use the power trim and tilt switch lo-
cated on the remote control device or tiller
handle, if equipped.
EMU27891
Adjusting trim angle for hydro tilt
models
WARNING
EWM00490
● Stop the engine before adjusting the
trim angle.
●
Be sure all people are clear of the out-
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
●
Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
1. Stop the engine.
2. Place the tilt lock lever in the release po-
sition.
3. Hold the rear of the top cowling with one
hand and tilt the engine to the desired
angle.
4. Place the tilt lock lever back into the lock
position to support the engine.
To raise the bow (“trim-out”), tilt the engine
up.
To lower the bow (“trim-in”), tilt the engine
down.
Make test runs with the trim set to different
angles to find the position that works best for
1. Power trim and tilt switch
1. Power trim and tilt switch
UP
DN
ZMU04060
1
ZMU04061
✩✪✰✬✤ ✦✪  