Owner`s manual

Operation
56
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then, install the clip on the other
end of the cord to the engine shut-off
switch.
3. Align the engine start mark “ ” on the
throttle grip with the notch in the tiller han-
dle.
TIP:
If the ambient temperature is -15°C or less,
turn the throttle grip so that the engine start
mark “ ” is positioned past the notch in the
tiller handle.
4. Pull out the choke knob fully.
TIP:
It is not necessary to use the choke when
starting a warm engine, such as immediately
after the outboard motor has been operated
under a load.
5. Pull the manual starter handle slowly until
you feel resistance. Then give a strong
pull straight out to crank and start the en-
gine. If the engine does not start on the
first try, repeat the procedure.
1. Neutral position
1. Start mark “ ”
2. Notch
1
ZMU06749
ZMU06744
ZMU06808
12
1. Choke knob
ZMU06865
ZMU06784
1
U6BV37E0.book Page 56 Wednesday, May 1, 2013 8:56 AM