Owner`s manual

Maintenance
85
2. Prepare a suitable container that holds a
larger amount than the engine oil capaci-
ty. Loosen and remove the drain screw
and gasket while holding the container
under the drain hole. Then remove the oil
filler cap. Let the oil drain completely.
Wipe up any spilled oil immediately.
3. Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
TIP:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into con-
tact with the surface of the drain hole. Then
tighten 1/4 to 1/2 turn more. Tighten the drain
screw to the correct torque with a torque
wrench as soon as possible.
4. Add the correct amount of oil through the
filler hole. Install the filler cap. NOTICE:
Overfilling the oil could cause leakage
or damage. If the oil level is above the
upper level mark, drain until the level
meets the specified capacity.
[ECM01850]
5. Turn off the engine and wait 3 minutes.
Recheck the oil level using the oil level
check window to be sure the level falls
between the upper and lower marks. Fill
with oil if it is below the lower mark, or
drain to the specified level if it is above
the upper mark.
1. Drain screw
2. Gasket
Drain screw tightening torque:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
2
1
ZMU02352
Recommended engine oil:
YAMALUBE 4M FC-W or 4-stroke
outboard motor oil
Engine oil quantity:
0.4 L (0.42 US qt, 0.35 Imp.qt)
1. Oil filler cap
U6BV37E0.book Page 85 Wednesday, May 1, 2013 8:56 AM