Service manual

SPEC
Specifications
33
69W3D1X
General torques
This chart specifies tightening torques for
standard fasteners with a standard ISO
thread pitch. Tightening torque specifications
for special components or assemblies are
provided in applicable sections of this man-
ual. To avoid warpage, tighten multi-fastener
assemblies in a crisscross fashion and pro-
gressive stages until the specified torque is
reached. Unless otherwise specified, torque
specifications require clean, dry threads.
Components should be at room temperature.
Bracket unit
Tiller handle assembly nut — 37 3.7 27
Engine shut-off switch nut — 20.21.4
Tiller handle bracket nut — 38 3.8 27
Engine start switch nut — 50.53.7
Tiller handle bracket bolt M5 7 0.7 5.1
Friction plate bolt M6 8 0.8 5.8
Friction plate self-locking nut — 40.42.9
Upper mount nut — 24 2.4 17
Lower mount nut — 42 4.2 30
Clamp bracket self-locking nut — 23 2.3 17
Power trim and tilt
Tilt cylinder end screw — 90 9.0 65
PTT motor bolt M5 4 0.4 2.9
Reservoir cap — 70.75.1
Trim cylinder end screw — 80 8.0 58
Tilt piston bolt M12 61 6.1 44
Relief valve bracket bolt M5 5 0.5 3.6
Gear pump assembly bolt M6 5 0.5 3.6
Gear pump bracket bolt M5 5 0.5 3.6
Electrical unit
Pulser coil screw — 40.42.9
Starter motor nut — 90.96.5
Part to be tightened Thread size
Tightening torques
N·mkgf·mft·lb
Nut (A) Bolt (B)
General torque
specifications
N·mkgf·mft·lb
8 mm M5 5 0.5 3.6
10 mm M6 8 0.8 5.8
12 mm M8 18 1.8 13
14 mm M10 36 3.6 25
17 mm M12 43 4.3 31