User Manual

16
DTX-PROX Owner’s Manual
Installing the DTX-PROX
Setup Guide
4.
Hook the AC adaptor’s cord around the cord
hook to secure it in place.
5.
Plug the AC adaptor’s AC plug into a domes-
tic power outlet.
 Connecting Headphones
Connect the headphones to the [PHONES] (headphone) jack.
To adjust the headphone volume, use the [PHONES] slider.
To adjust the headphone EQ, set the Fader Select knob to
“CUSTM,” and use the LED rotary faders.
One standard stereo phone jack and one stereo mini phone
jack are available. Select the proper jack that matches the con-
nector size of the cable. The output volume may be lower than
expected if both phone jacks are used at the same time.
CAUTION
Excessive bending can damage the AC adaptor cord
and create a fire hazard. Ensure, therefore, that the
power cord is not bent at an extreme angle when
wrapped around the hook.
CAUTION
Even when the [ ] (Standby/On) switch is in standby
status (display is off), electricity is still flowing to the
instrument at the minimum level.
When you are not using the DTX-PROX for a long
period of time, make sure that you unplug the AC
adaptor from the wall AC outlet.
NOTE
When disconnecting the AC adaptor, turn the instrument and then carry out this procedure in reverse order.
CAUTION
Do not use headphones at high volume for an extended
period of time. Doing so can cause loss of hearing.
Cord hookAC adaptor cord
Power outlet
AC adaptor
Front panel side