Owner`s manual

INSTRUMENT AND CONTROL FUNCTIONS
3-21
3
5. Insert the projection on the front of
the seat into seat holder B as
shown.
6. Align the projection on the bottom
of the seat with the “H” position
slot, and then push the rear of the
seat down to lock it in place as
shown.
To change the seat height to the low
position
1. Remove the seat. (See page
3-19.)
2. Remove the seat height position
adjuster by pulling it upward.
3. Move the seat holder cover to the
upper position.
4. Install the seat height position ad-
juster so that the “L” mark is
aligned with the match mark.
5. Insert the projection on the front of
the seat into seat holder A as
shown.
1. Seat height position adjuster
2. “H” mark
3. Match mark
1. Projection
2. Seat holder B (for high position)
3. Seat holder cover
1. “H” position slot
1. Seat height position adjuster
2. “L” mark
3. Match mark
1. Projection
2. Seat holder A (for low position)
3. Seat holder cover
U5P5E0E0.book Page 21 Tuesday, March 21, 2006 12:00 PM