Owner`s manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-30
6
EAU40990
Replacing a rear turn signal
light bulb or a tail/brake light
bulb
1. Remove the socket (together with
the defective bulb) by turning it
counterclockwise.
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the socket (together with the
bulb) by turning it clockwise.
EAU24310
Replacing the license plate
light bulb
1. Remove the license plate light unit
by removing the screws.
2. Remove the socket (together with
the bulb) by pulling it out.
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
1. Turn signal light bulb socket
2. Tail/brake light bulb socket
1. Screw
2. License plate light unit
1. License plate light bulb
U5P5E0E0.book Page 30 Tuesday, March 21, 2006 12:00 PM