Operation Manual

INSTRUMENT AND CONTROL FUNCTIONS
3-11
3
Ambient temperature mode
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
● If the ambient temperature falls be-
low –9 °C, a lower temperature
than –9 °C will not be displayed.
● If the ambient temperature climbs
above 50 °C, a higher temperature
than 50 °C will not be displayed.
● The accuracy of the temperature
reading may be affected when
riding slowly (approximately under
20 km/h) or when stopped at traffic
signals, railroad crossings, etc.
Instantaneous fuel consumption mode
The instantaneous fuel consumption
display can be set to either “km/L” or
“L/100 km”.
● When the display is set to “km/L”,
the distance that can be traveled
on 1.0 L of fuel under the current
riding conditions is shown.
● When the display is set to “L/100
km”, the amount of fuel necessary
to travel 100 km under the current
riding conditions is shown.
TIP
● To switch between the two instan-
taneous fuel consumption dis-
plays, push the reset button for 1
second when either display is
shown.
● If traveling at speeds under 10
km/h, “_ _._” will be displayed.
Average fuel consumption mode
This display shows the average fuel
consumption since it was last reset.
The average fuel consumption display
can be set to either “AV_ _._ km/L” or
“AV_ _._ L/100 km”.
1. Ambient temperature
1. Instantaneous fuel consumption
1. Average fuel consumption
U1DAE1E0.book Page 11 Tuesday, August 24, 2010 5:28 PM