Owner`s manual

INSTRUMENT AND CONTROL FUNCTIONS
3-12
3
NOTE:
● The shift pedal can be used to shift
gears whether the hand shift lever
is enabled or not.
● When the main switch is turned to
“OFF”, the hand shifting mode will
automatically be disabled. Press
and release this switch after start-
ing the engine to enable hand
shifting.
EAU40492
Shift pedal
This vehicle is equipped with a con-
stant-mesh 5-speed transmission. The
shift pedal is located on the left side of
the engine. Neutral is at the bottom po-
sition.
NOTE:
It is impossible to shift gears unless the
main switch is in the “ON” position.
The shift pedal can be adjusted to three
positions to suit the rider’s preference.
To adjust the shift pedal position
1. Remove the shift pedal by remov-
ing the bolt.
2. Move the shift pedal to the desired
position.
3. Install the bolt, and then tighten it
to the specified torque.
1. Shift pedal
1. Shift pedal
2. Bolt
3. Standard position
Tightening torque:
Shift pedal bolt:
6.5 Nm (0.7 m·kgf, 5.0 ft·lbf)
U2D21AE0.book Page 12 Monday, June 26, 2006 2:18 PM