Owner`s manual

INSTRUMENT AND CONTROL FUNCTIONS
4-8
4
NOTICE
ECA10021
Do not continue to operate the en-
gine if it is overheating.
Transmission gear display
This display shows the selected gear.
The neutral position, however, is not
displayed, it is indicated by the neutral
indicator light.
To avoid damaging the YCC-S clutch,
the display flashes when it is necessary
to downshift. If this occurs, downshift
until the display stops flashing.
Ambient temperature, instanta-
neous fuel consumption and aver-
age fuel consumption modes
Push the reset button to switch the dis-
play between the ambient temperature
mode “Air”, the instantaneous fuel con-
sumption mode “MPG” and the aver-
age fuel consumption mode “AV_ _._
MPG” in the following order:
Air → MPG → AV_ _._ MPG → Air
Ambient temperature mode
This display shows the ambient tem-
perature from 16 °F to 122 °F in 1 °F in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
● If the ambient temperature falls be-
low 16 °F, a lower temperature
than 16 °F will not be displayed.
● If the ambient temperature climbs
above 122 °F, a higher tempera-
ture than 122 °F will not be dis-
played.
● The accuracy of the temperature
reading may be affected when
riding slowly [approximately under
1. Transmission gear display
2. Neutral indicator light “”
1. Ambient temperature/instantaneous fuel
consumption/average fuel consumption
2. Select button
3. Reset button
1. Ambient temperature
U2D213E0.book Page 8 Friday, September 26, 2008 3:12 PM