Owner`s manual

Control functions
35
FX10XT
The compression damping force can be ad-
justed by turning the adjusting knob.
To increase the compression damping force,
turn the adjusting knob in direction (a). To de-
crease the compression damping force, turn
the adjusting knob in direction (b).
ESU11034
Adjusting the control rods (FX10XT)
WARNING
EWS00770
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
The weight transfer can be adjusted by turn-
ing the adjusting nuts on the control rods.
1. Loosen the locknut while holding the ad-
justing nut.
2. To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
Compression damping force setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
6 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting screw fully turned
in direction (a)
1. Compression damping force adjusting knob
Compression damping force setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
6 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
(b)
(a)
1
1. Locknut
2. Control rod adjusting nut
U8HK13E0.book Page 35 Monday, May 9, 2011 4:06 PM