Owner`s manual

Control functions
16
ESU10674
Grip/thumb warmer adjustment
switch
The grip/thumb warmer adjustment switch
controls the electrically heated handlebar
grips and throttle lever.
To raise the temperature
To raise the grip warmer temperature, press
the “” side of the switch. To raise the thumb
warmer temperature, press the “” side of
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
See “Fuel meter and grip/thumb warmer level
indicator” on page 12 for detailed information.
ESU13520
Brake lever
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
TIP
When the brake lever is operated, the brake
light will illuminate.
The brake lever is equipped with a position
adjuster.
To adjust the brake lever position:
1. Loosen the locknut.
2. While lightly pushing the brake lever in di-
rection (a), finger tighten the adjusting
bolt to set the brake lever to the desired
position.
3. Tighten the locknut securely after adjust-
ing the brake lever.
1. Headlight beam switch “LIGHTS”
2. High beam “HI”
3. Low beam “LO”
1. Grip/thumb warmer adjustment switch
1. Brake lever
1. Locknut
2. Adjusting bolt
U8HK11E0.book Page 16 Thursday, April 9, 2009 8:43 AM