Owner`s manual

Control functions
18
ESU10722
Shroud and covers
Securely fasten the shroud and covers before
operating the snowmobile. (See page 44 for
removal and installation procedures.)
ESU12733
Drive guard
WARNING
EWS00401
● Coming in contact with the rotating V-
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
● Make sure that the drive guard is tight-
ened securely before operating the
snowmobile to protect against severe
injury or death from a broken V-belt or
other part should it come off the snow-
mobile while it is in operation.
NOTICE
ECS00830
Never run the engine with the V-belt re-
moved. Clutch components can be dam-
aged.
The drive guard is designed to protect the V-
belt clutch and V-belt in case parts break or
come loose.
The drive guard is located behind the left side
cover. (See page 44 for removal procedures.)
To remove the drive guard
1. Pull out the drive guard locking pin from
the drive guard rear holder.
2. Lift up the rear of the drive guard as
shown, and then pull the guard rearward
to remove it.
To install the drive guard
1. Insert the projections on the drive guard
front holder into the slots in the front of the
drive guard.
1. Shroud
2. Right side cover
1. Left side cover
1
2
1
1. Drive guard
2. Drive guard locking pin
1
2
U8HK11E0.book Page 18 Thursday, April 9, 2009 8:43 AM