Owner`s manual

Periodic maintenance and adjustment
57
4. Pull the V-belt up over the secondary
fixed sheave.
5. Remove the V-belt from the secondary
sheave assembly and primary sheave
assembly.
6. Temporarily install the new V-belt on the
secondary sheave assembly only, and
then measure the V-belt position. Do not
force the V-belt between the sheaves; the
secondary sliding and fixed sheaves
must touch each other.
7. If the V-belt position is incorrect, adjust it
by removing or adding a spacer on each
V-belt position adjusting bolt.
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
1. Edge of the secondary sheave assembly
2. V-belt position
Standard V-belt position:
From 1.5 mm (0.06 in) above the edge
of the secondary sheave assembly to
0.5 mm (0.02 in) below the edge
U8HK11E0.book Page 57 Thursday, April 9, 2009 8:43 AM