Service manual
5-81
E
POWR
CRANKCASE
2. Apply:
• Gasket Maker
®
(onto the crankcase mating surfaces)
NOTE:
Do not allow any Gasket Maker
®
to come into
contact with the oil gallery or crankshaft journal
bearings.
3. Install:
• Dowel pins 1
• O-ring 2
GM
1
1
2
1
4. Install:
• Crankcase bolts
NOTE:
• Lubricate the bolt 1–0 threads and wash-
ers with engine oil.
• Finger tighten the crankcase bolts.
M9 × 105 mm bolts: 1–0
M6 × 55 mm bolts: A–F
M6 × 55 mm bolts: G, H
M6 × 70 mm bolts: I
M6 × 55 mm bolts: J
8 6 2 4
0
9
3
1
5
7
I
C
AE
G
H
FB
D
J
5. Tighten:
• Crankcase bolts 1–0
NOTE:
• Do not reuse crankcase bolts 1–0.
• The tightening procedure of crankcase bolts
1–0 is angle controlled, therefore tighten
the bolts using the following procedure.
8 6 2 4
0
9
3
1
5
7
I
C
AE
G
H
FB
D
J