Service manual

6-18
E
JET
PUMP
IMPELLER DUCT AND DRIVE SHAFT
5. Install:
• Rear bearing
NOTE:
• Press the bearing inner/outer race at the
same time holding the drive shaft and impel-
ler duct.
• If a bearing inner/outer race attachment is
not available, use a washer or pipe with an
outer diameter of 46 mm (1.81 in) and an
inner diameter of 20 mm (0.79 in).
Bearing inner/outer race
attachment:
YB-34474
6. Add:
• EPNOC grease AP #0 (into the cap)
Quantity:
Approximately 1/3 of capacity
7. Install:
• Nut
• Impeller
Drive shaft holder:
YB-06151/90890-06519