Service manual

6-29
E
JET
PUMP
BEARING HOUSING
3. Install:
• Oil seal
1
[8 mm (0.31 in)]
• Oil seal
2
[11 mm (0.43 in)]
Distance
a
:
10.3–10.7 mm (0.41–0.42 in)
Distance
b
:
0.6–1.0 mm (0.02–0.04 in)
b
a
2
1
Intermediate housing installation
1. Install:
• Intermediate housing
• Shim
NOTE:
Install the shim(s) to the original position if the
intermediate housing is not replaced.
Installation steps:
• Install the intermediate housing.
• Measure the clearance
a
at each bolt
hole.
• Install the suitable shim from the table
below.
Clearance
a
Shim thickness
0–0.2 mm
(0–0.008 in)
No need
0.3–0.7 mm
(0.012–0.028 in)
0.5 mm
0.8–1.2 mm
(0.031–0.047 in)
1.0 mm
1.3–2.0 mm
(0.051–0.079 in)
1.5 mm