Service manual

8-7
E
HULL
HOOD
HANDLEBAR
3. Install:
• Throttle cable
NOTE:
Fit the seal into the groove in the bracket.
4. Adjust:
• QSTS cable length
a
NOTE:
• Before adjusting the QSTS cables, set the
trim grip to the neutral position.
• Adjust the QSTS cable lengths
a
to the
specified length and be sure to take up any
slack.
QSTS cable length:
72
±
0.5 mm (2.83
±
0.02 in)
5. Install:
• Handlebar cover
1
NOTE:
When the handlebar cover is in contact with
the steering boss cover, adjust the handlebar
mount angle so that the clearance
a
and
b
are equal.
6. Adjust:
• Throttle cable free play
Refer to “CONTROL SYSTEM” in Chap-
ter 3.
7. Adjust:
• QSTS cable
Refer to “CONTROL SYSTEM” in Chap-
ter 3.