Service manual

9-33

TRBL

ANLS

OPERATING

Operating injector procedure:

A voltage is applied to the injector of the selected cylinder, the injector is activated, and then the fuel

system is checked. The fuel is injected 20 times within two seconds.

WARNING

• Do not perform the test with the injector removed from the throttle body or with any fuel

system parts removed. High-pressure fuel could spurt out.

• When performing this operation, keep all sparks, flames, or other sources of ignition away

from the testing area. Gasoline is highly flammable.

1. Select the test that you wish to perform by either clicking it or pressing the up or down arrow

keys on your keyboard. (Fig. 48)

Fig. 48

NOTE:

• Make sure that the engine is not running.

• The selected item is highlighted in light blue.

• The details of the selected test are displayed in the column on the right, and the items that must

be either checked or performed before the test can start are displayed below the table.

• Only one item can be selected at one time.

• Make sure that there is fuel in the fuel tank, otherwise an error will occur and the test cannot be

performed.

2. Select the cylinder to be tested, and then click the

Select

button or press the Enter key on your

keyboard. (Fig. 48)