Service manual

3-6
E
INSP
ADJ
CONTROL SYSTEM
2. Adjust:
• QSTS cable
NOTE:
If the QSTS cable cannot be properly adjusted
by the cable joint at the QSTS converter end,
adjust the cable joint at the jet pump end so
that the same lengths are obtained. Refer to
“REMOTE CONTROL CABLES AND SPEED
SENSOR LEAD” in Chapter 8.
Adjustment steps:
• Set the control grip in the neutral position.
• Loosen the locknut
1
.
• Remove the nut
2
and pivot pin
3
.
• Set the jet thrust nozzle in the center
position.
• Turn the cable joint
4
for adjusting.
Turn in Length
a
is increased.
Turn out Length
b
is increased.
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
• Connect the cable joint
4
and pivot pin
3
and tighten the nut
2
.
T
R
.
.
Nut:
3.8 N • m (0.38 kgf • m, 2.7 ft • lb)
• Tighten the locknut
1
.
T
R
.
.
Locknut:
3 N • m (0.3 kgf • m, 2.2 ft • lb)