Service manual

3-27
E
INSP
ADJ
JET PUMP UNIT/BILGE PUMP
Water inlet strainer inspection
1. Inspect:
• Water inlet strainer
Contaminants
→
Clean.
Cracks/damage
→
Replace.
Inspection steps:
• Remove the ride plate.
Refer to “INTAKE GRATE, RIDE PLATE,
AND INTAKE DUCT” in Chapter 6.
• Remove the rubber plate.
Refer to “JET PUMP UNIT” in Chapter 6.
• Remove the water inlet cover
1
.
• Inspect the water inlet strainer mesh
a
.
• Install the water inlet cover.
• Install the rubber plate.
Refer to “JET PUMP UNIT” in Chapter 6.
• Install the ride plate.
Refer to “INTAKE GRATE, RIDE PLATE,
AND INTAKE DUCT” in Chapter 6.
BILGE PUMP
Bilge strainer inspection
1. Inspect:
• Bilge strainer
Contaminants
→
Clean.
Cracks/damage
→
Replace.
Inspection steps:
• Remove the deck beam.
Refer to “SEATS AND HAND GRIP” in
Chapter 8.
• Remove the coupling cover.
• Disconnect the bilge strainer
1
from the
bilge strainer holder.
• Inspect the bilge strainer.
• Install the coupling cover.
• Install the deck beam.
Refer to “SEATS AND HAND GRIP” in
Chapter 8.
1