Installation manual

CAUTION: The next steps involving the use of heat to soften the sealant material
used to prevent condensation and water vapor build up inside the LED
enclosure. Be careful when heating the plastic because overheating or
overexposure can cause physical deformities in the plastic that are not
repairable. Please follow guidelines carefully.
Some users have been able to perform the next steps using either a hot air gun
or hair dryer. These methods can be employed in substitute of the oven but we
found that the heating is more difficult, less even, and takes longer. Please feel
free to attempt these methods if you do not feel comfortable placing your tail
light assembly into an oven.
Step 5: Preheat empty oven to 260°F [127°C].